Automatic door openers are usually used to realize the electric opening and closing of various doors. Compared with ordinary door closers, it has a lot of attention to repair, maintenance and cleaning. The following will give you a targeted introduction to these three aspects, and I hope it will be helpful to you.
1. Maintenance of automatic door opener:
1. Remote battery is dead: Do you remember the last time you changed the batteries in your remote? If your remote automatic door opener suddenly stops the signal for the door, consider whether the battery is dead before calling for repair. Remote batteries typically take about two years to replace.
2. Remote signal interruption: After putting new batteries into the remote control, if the door still does not respond, the signal between the remote control and the remote automatic door opener may be interrupted. Two common causes of signal loss are if your remote is out of range, or if the opener's receiving antenna is damaged.
3. The lock button is engaged: Another easy fix is to make sure the lock button on the wall-mounted control panel is not pressed. You may accidentally press this button while performing normal day-to-day activities and the door lock can be easily disengaged by pressing the lock button. After unlocking the door, test the operation of the door by pressing the panel's open button.
4. Door control wiring failure: If the remote and wall-mounted panel methods cannot open the door, there may also be a problem with the control wire of the door system or the receiver board of the opener.
2. Maintenance of automatic door opener:
1. The transmission part of the door machine should be kept clean and free of attachments.
2. Frequently clean up the sundries in the subway trough.
3. Add lubricating oil to each mechanical moving part properly every quarter.
4. Check the power protection device and backup power storage performance once a month.
Note: The maintenance of the automatic door opener should be carried out by specialized technicians
3. Automatic door opener cleaning;
Internal cleaning Clean the inner wall and various accessories of the automatic door opener with a mild detergent, and then dry them with a soft cloth. For a more thorough cleaning, you can take out some accessories, dry them before putting them back in place.
External Cleaning Clean the digital panel with a soft, clean cloth. Sprinkle water on the cleaning cloth instead of spraying water directly on the surface of the automatic door opener, so that the humidity on the surface can be even. Automatic door openers, handles and cabinet surfaces should be cleaned with a mild detergent and then dried with a soft cloth.
Do not use benzene, thinner or bleach for cleaning. They will damage the finish of the automatic door opener and have the potential to start a fire. WARNING: Do not spray water on the automatic door opener while the automatic door opener is powered on, or it could cause electric shock and even cause problems. If the exterior of the automatic door opener is made of stainless steel, it needs to be wiped once or twice a year.
