How to install and debug the 90 degree door opener?

1. Preparations for the installation of the door opener: first of all, we need to check whether the flexibility of opening and closing the door is very good; then we need to determine the inner ground drop corresponding to the corresponding operating range of the door operator; we need to determine the configuration power of the door operator.
2. Determination of the installation position of the door opener: First, we need to fix the relative installation position when the two doors are closed. The corresponding inner margin of the two door operators must be greater than 100mm, so that it will not affect the manual door opening.
3. Height adjustment of the fixing plate for the installation of the door opener: The purpose of setting the corresponding installation height of the fixing plate is to determine the position of the door opener. There are two methods. When installing the fixed plate, we can push the gate to the lowest part of the walking range, and move the corresponding fixed plate to make it 60-110 mm above the ground for marking. Another method is similar.
4. Laying wires for the installation of the door opener: This link is an important link in the installation of the door opener, because all the controls are here.
First of all, make holes in the bottom frame of the gate for the wires to enter and exit, and refer to the drawings for the corresponding connections.
5. Fixed door opener for door opener installation: When fixing the door opener, we should pay attention to the connected wires. It should be noted that it should be consistent with the corresponding logo color of the wiring seat inside the controller. The next step is to check, switch to manual to push the door forward and backward, at this time, keep the power on and run freely with the ups and downs of the ground.