Install electric sliding door
We are installing the electric sliding door. In order to make the electric sliding door work better in the follow-up work, it is necessary to carry out relevant safety settings for the automatic door. The settings are as follows:
1: In the event of a power failure or failure, the door leaf can be opened manually, and the door opening force is not greater than 100N.
2: The electric sliding door is equipped with 2 pairs of safety films, which can realize the purpose of protecting pedestrians, objects and the safety of the electric sliding door itself. One pair of electric eyes is installed with a height of 200mm from the ground and the other with a height of 1000mm from the ground, which can protect not only children or pets who are not tall, but also ordinary adults. The arc sliding door uses a microwave and infrared integrated sensor.
3: Automatic doors must be equipped with smart electronic mechanical locks with good safety performance (both electric lock and manual mechanical lock functions), which can be opened manually in the event of a power failure or failure. The lock should be able to be linked with firefighting. In the event of a fire, the door leaf can be automatically opened to facilitate the evacuation of people in the building, and the use mode of the lock can be set through the mode switch, including power-off unlocking (applicable to daily working hours) and power-off locking (Suitable for unattended at night) Two modes. (Using the concealed installation of the intelligent electronic mechanical lock can not only meet the aesthetic requirements but also improve the safety performance)
4: Considering the relatively high wind pressure in coastal areas, for smooth automatic doors installed at the entrance on the first floor outdoors, positioning chutes must be set on the ground below the door leaf to prevent the door leaf from swinging. The chutes must not protrude from the ground finish surface. Open the two lower sides of the door leaf. Support points must be installed near the corners, and the total number of support points shall not be less than 2.
